The diagram above is all of the parts and what they were made of.
Construction of My E-11 Blaster
**Danger**
You can get hurt using tools so take the time to read the instructions and safety manual before doing something that can get you hurt! I recommend to always wear safety glasses, because without your sight you couldn't watch Star Wars movies or finish making your blaster!!!
The Body
Step 1 - Take the 15" X 1 1/4" PVC pipe and cut it into two pieces one 3" and the other 12". Take the 3/4" coupler and cut it in half ( I used my dremel)make sure to cut it a little off center so the center block is only on one side of the coupler. The blocked half goes onto the end of the 3/4" X 8" pvc pipe, the other half sits about 1/2" back from the tip of the other end. Use silicone or some other adhesive to attach these pieces together, then sand them down. Go ahead and paint this piece now because it will be hard to do when it's inside the barrel.